25
Replacing the cooking compartment bulb
Heat-resistant 230 V/25 W halogen bulbs with seals are
available from the after-sales service. Please specify the E
number and FD number of your appliance.
:
Risk of burns!
Allow the cooking compartment and cooking compartment light
to cool before changing the bulb.
Always use a dry cloth to remove a new halogen bulb from the
packaging, otherwise it will not last as long.
1.
Switch off the fuse in the fuse box or unplug at the mains.
2.
Turn the cover anti-clockwise to remove.
3.
Remove the bulb and replace with a bulb of the same type.
4.
Slide the new seals and the clamping ring onto the glass
cover in the right order.
5.
Screw the glass cover with the seals back on again.
6.
Connect the appliance to the mains and reset the clock.
Never operate the appliance without the glass cover and seals.
Replacing the glass cover or seals
Any damaged glass cover or seals must be replaced. Please
provide the after-sales service with the E number and FD
number of your appliance.
Changing the door seal
If the seal around the outside of the cooking compartment is
faulty, it must be replaced. Replacement seals for your
appliance can be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
1.
Open the appliance door.
2.
Pull off the old seal.
3.
Push in the new door seal at one point and pull it in all the
way round. The joint must be at the side.
4.
Check again that the seal is correctly fitted in the corners.
Steam escapes from the ventilation slots
during cooking
This is normal
When types of heating involving steam are
used, water drips from the moisture sensor
on the cooking compartment ceiling
This is normal. Steam condenses on the
moisture sensor
The appliance is not producing steam
properly
Limescale has formed in the appliance
Start the descaling programme.
The fault message “E011” appears on the
display
A button was pressed for too long or is
jammed
Press the
0
button to clear the fault mes-
sage. Press all of the buttons individually
and check if they are clean
An “E...” fault message appears in the dis-
play
Technical fault.
Press the
0
button to delete the error
message. Reset the clock if required.
If the error message appears again, call
the after-sales service
The appliance is not heating. “Demo” is
shown on the display
A button combination was actuated
Disconnect the power supply and recon-
nect it after 10 seconds. Within 2 minutes,
press the
D
button for 4 seconds
Problem
Possible cause
Notes/remedy
Содержание HBC38D754
Страница 1: ... en Instruction manual Combination steam oven HBC38D754 ...
Страница 2: ......