Bosch FWA 43 Series, Инструкция по техническому обслуживанию

Страница: 44 / 60

1 690 326 006 2008-8-25
|
Robert Bosch GmbH
en 44 | FWA 43xx / 44xx | Operating System-Software
Control panel 14.9.2
The main operating elements of the program are
summarised in a panel on the left corner of the
window.
Operating element Fig. 8:
Display of the Version and type. 1.
VIEW … Viewer (Standard) – Variant.
SERV … Service – Variant (on the Service-CD).
Interface settings, to which the wheel alignment
2.
gauge is connected.
Serial: This setting is valid for the CCD wheel
alignment gauge. The number of serial interface are
determined automatically by the program.
'Read' reads the data from EEPROMs and/or RAMs of
3.
the selected equipment.
'Write' (Writing data) is available only in specific
situations and is possible only with the service
version of the Sysmonitor.
The data of the camera processors is reflected in
the memory of the measuring processor. With the
help of the option 'Camera Data from', it can be
determined whether the data should be read directly
by the camera or should read its copy from the
measuring processor.
The content of the current screen page can be saved 4.
in an XML file. With 'Write', the screen page is saved
and with 'Read' the content of the file is displayed in
the current screen view. Thereby, the file suitable for
currently selected screen view must be opened, in
other case it is not displayed.
With 'All', all the equipments are selected, with
5.
'None' the option is reset completely.
Here, different functions are provided (partially it is
6.
dependent on the screen view), in order to effect the
screen view or the provision of data.
Closing the System Monitor.
7.
Register card "Type and version info" 14.9.3
The data block with the type and the version
information from the selected equipments is read and
displayed. Every equipment (communication processor,
measuring processor and camera processor) has an
individual display block with an individual colour for
the equipment type, which is also used in the following
screen views.
Following colour scheme is used:
Display block Colour
Communication processor (KP) - yellow
Measuring processor (MP) green
Camera processor (CP) for
camera 1 (Transverse track)
dark ochre
Camera processor (CP) for
camera 2 (Longitudinal track)
light ochre
Colour scheme Tab. 4:
Option button Fig. 9:
An equipment is selected by clicking on the 'option'
button on the right near the description of the element.
This option is also available on the display blocks in
other screen views.
With the button "all", all the equipments are selected.