Bosch FLEXIDOME PMT-DOME, Руководство по установке

Страница: 5 / 10

FLEXIDOME Wall and Pipe Mounts Installation | en 5
Bosch Security Systems Installation manual | v4.0 | 2014.03
3 Installation
This installation should be made by qualified service personnel and conform to the National
Electrical Code and applicable local codes.
3.1 Installing the Wall Mount
Figure 3.1 Wall Mount installation
1. Determine location for wall mount.
2. Use the mount as template to mark the location of the mount holes on the wall.
3. Drill holes for anchors and install anchors into wall.
4. Drill a fifth hole in the wall that is aligned with the feed-through tube in the mount. This
hole is used to feed wires through the tube.
5. Use approximately 10 turns of the teflon tape on the thread of the mount to ensure
protection against water/dirt ingress. Apply some anti-seize grease to the thread before
attaching.
6. Attach the mount to the wall.
7. Connect all wires to the camera.
8. Pull any excess wire back into the mount tube.
9. Attach the camera to the mount with the three M5 screws supplied.
10. Insert the rubber gasket between the wall mount dome and the camera dome housing
cover.
11. Attach the camera dome housing cover.