FLEXIDOME panoramic 5100i | FLEXIDOME
panoramic 5100i IR
Configuration | en
45
Bosch Security Systems B.V.
User manual
2022-01 | V01 | F.01U.385.628
Authentication password
Enter the appropriate password for authentication.
Privacy protocol
Select the appropriate privacy protocol: None, DES, or AES.
Privacy password
Enter the appropriate password.
Read-only
To make this information read-only, select this check box.
Quality of service
The camera offers Quality of Service (QoS) configuration options to ensure fast network
response to PTZ data and images. Quality of Service (QoS) is the set of techniques to manage
network resources. QoS manages the delay, delay variation (jitter), bandwidth, and packet
loss parameters to guarantee the ability of a network to deliver predictable results. QoS
identifies the type of data in a data packet and divides the packets into traffic classes that can
be prioritized for forwarding.
Consult with your network administrator for assistance configuring the
Audio
,
Video
,
Control
,
and the
Alarm video
settings, and to select the appropriate
Post-alarm time
.
Post-alarm time
has a time period from 0 s [seconds] to 3 h [hours]; 15 s [seconds] is the
default option.
Click
Set
to apply the changes.
Some changes only take effect after the unit is rebooted. In this case, the
Set
button changes
to
Set and Reboot
.
4.7.5
Multicast
The device can enable multiple receivers to receive the video signal simultaneously. The
stream is either duplicated and then distributed to multiple receivers (Multi-unicast), or it is
sent as a single stream to the network, where it is simultaneously distributed to multiple
receivers in a defined group (
Multicast
).
Multicast
operation requires a multicast-enabled network that uses
UDP
and the Internet
Group Management protocol (
IGMP
V2). The network must support group IP addresses. Other
group management protocols are not supported. The
TCP
protocol does not support multicast
connections.
A special IP address from 225.0.0.0 to 239.255.255.255 (class D address) must be configured
for multicast operation in a multicast-enabled network. The multicast address can be the same
for multiple streams, however, it is necessary to use a different port in each case.
The settings must be made individually for each stream. Enter a dedicated multicast address
and port for each stream.
The video channels can be individually selected for each stream.
Enable
Enable simultaneous data reception on receivers that need to activate the multicast function.
To do this, check the box and enter the multicast address.
Multicast Address
Enter a valid multicast address to be operated in multicast mode (duplication of the data
stream in the network).
