Bosch EV300, Руководство оператора

Страница: 9 / 21

SP01502138 Ver.00
|
© Bosch Automotive Service Solutions Inc.
Status Blue Green Red Notes
RCD abnor-
mal stop
charging*1
Steady
Bright
Steady Bright C* 2
Output
OCP Stop
Charging*1
Steady
Bright
Steady Bright C* 2
OTP
Stop
Charging
Flash-
es
Flash-
es
Steady Bright C
A = Auto recover
C = Contact technical support
*1 Disconnect and reconnect the charging plug to exit this
charging mode.
*2 If this mode is frequently triggered, contact technical
support.
10.2 The EV 300 Fails to Power Up
The EV 300 should power up as soon as exter-
nal power is applied. If the EV 300 does not
turn on, follow the recommendations below:
Recommendations
¶
Check that EV 300 power cable is securely
plugged in to the outlet.
¶
Check breaker to ensure power to the outlet
¶
Try supplying power to the EV 300 from a
different power source.
11. Warranty
THIS LIMITED WARRANTY IS EXPRESSLY
LIMITED TO THE ORIGINAL PURCHASER
(“PURCHASER”) OF THE BOSCH EV300 SERIES
CHARGING STATION (“CHARGING STATION”).
IMPORTANT: It is the Purchaser’s obligation to
register the Charging Station with Bosch and
failure to do so may delay warranty support.
To register a Charging Station Online, go to
BoschEVSolutions.com or call 1-877-805-3873
or a regional vendor for assistance.
Bosch Automotive Service Solutions Inc.
(“Bosch”) warrants to the Purchaser that the
Charging Station will be free from defects in
materials and workmanship for a period of
three years from the date of purchase (“War-
ranty Period”). This warranty is valid for pur-
chasers located in the U.S.A. and Canada only.
ALL WARRANTY CLAIMS MUST BE MADE WITH-
IN THE WARRANTY PERIOD AND PROOF OF
PURCHASE ACCEPT¬ABLE TO BOSCH MUST BE
SUPPLIED.
9.2 Changing Location
$
If the EV 300 is handed over to someone
else, hand over all associated documenta-
tion included in the scope of delivery.
$
The EV 300 must only be transported in
the original or equivalent packaging.
$
Read and follow the instructions concern-
ing initial commissioning.
$
Disconnect the electrical port.
9.3 Disposal
EV 300, accessories, and packag-
ing must be recycled in an environ-
mentally friendly manner—accord-
ing to local and federal regulation.
¶
Do not dispose of the EV 300 in
general trash.
10. Troubleshooting
This section is intended to help you get back
on track if the EV 300 appears to be operating
abnormally. If the error is not eliminated by the
indicated remedy, it is necessary to contact
technical support.
10.1 Status Codes
.
Status Blue Green Red Notes
Input OVP 1 flashes, then
3 sec pause
A
Input UVP 2 flashes, then
3 sec pause
A
Output OCP 3 flashes, then
3 sec pause
A
OTP 4 flashes, then
3 sec pause
A
RCD Abnor-
mal
5 flashes, then
3 sec pause
A
Ground
fault
6 flashes, then
3 sec pause
A
Control pi-
lot fault
Flicker A
MCU self-
test fail
Steady Bright C
RCD self-
test fail
Steady Bright C
Relay self-
test fail
Steady Bright C
Troubleshooting | EV 300 | 9 en