30
Press "Select"
Display
Meaning/function
The analyzer then automatically switches to the "
Ab5o
Ab5o
Ab5o
Ab5o
Ab5o
" fine-
tuning function.
The display "700" appears in the CO display field.
Adjustment range: 700 hPa to 1100 hPa
Perfrom fine-tuning with the "Enter
o
" or "Test
u
" buttons.
After this, do not press any buttons; wait.
After two seconds, "
End
End
End
End
End
" appears, the analyzer has provisio
nally accepted the value (the pressure must have remained
constant until this moment).
As with fine-tuning of the first reference point, now acknow-
ledge your entry by simultaneously pressing the "Enter
o
"
and "Test
u
" buttons.
This finalizing routine is the same after the fine-tuning of both
reference points, even if the second reference point has
been fine-tuned in cm water gauge.
The analyzer conforms correct fine-tuning with the display
"
i.0.
i.0.
i.0.
i.0.
i.0.
" (OK) in the engine-speed display field.
Open the zero-gas inlet of the analyzer so that the air-
pressure gauge can set itself to ambient pressure.
Only
then
, press the "Select" button; the analyzer now quits fine-
tuning.
6.6
Recognition of chopper motor
i
Set function switch S 60 to setting
1
Press "Select"
Display
Meaning/function
5 x
An automatic sequence takes place:
The counter in the engine-speed display window counts
backwards from
"15"
to
"0"
. During this time, the exhaust-
gas analyzer recognizes which chopper motor is installed.
The following identification codes may appear:
PHiL
PHiL
PHiL
PHiL
PHiL
= Phillips/Valvo motor or interchangeable model.
bEr9
bEr9
bEr9
bEr9
bEr9
= Berger motor or interchangeable model.
6.7
Procedure for setting appropriate version for country of use
i
Set function switch S 60 to setting
2
Press "Select"
Display
Meaning/function
5 x
With the "Enter
o
" or "Test
u
" buttons, select the desired
setting. The following settings are available:
U 13 U
U 13 U
U 13 U
U 13 U
U 13 U
= Standard
U 13 E
U 13 E
U 13 E
U 13 E
U 13 E
= UK
U 13 C
U 13 C
U 13 C
U 13 C
U 13 C
= not used
U 13 b
U 13 b
U 13 b
U 13 b
U 13 b
= Brazil
984 700
Ab5o bo.Ei
984 980
i.0. bo.Ei
15 Ch.Ei
PHiL Ch.Ei
U13U tY.Ei
Содержание ETT 008.31
