Bosch DICENTIS, Руководство по настройке

Страница: 121 / 134

DICENTIS Hints and Tips | en 121
Bosch Security Systems B.V.
Configuration manual
2021.06 | V3.7 |
14.22 Configuring Dante™ compatible devices
The DICENTIS Conference System supports integration with third party Dante
TM
compatible
devices (like for example, a laptop). Configuring which Dante
TM
inputs and outputs are routed
to the Dante
TM
inputs and outputs of the DICENTIS Conference System is done via Audinate’s
Dante Controller which can be downloaded from the Audinate website.
Note: The Dante Virtual Device is running on the DICENTIS Conference System server for the
Dante
TM
functionality. Only one Dante
TM
device can be active on a computer, therefore it is not
possible to install any other Dante
TM
device on the DICENTIS Conference System server.
Note: The Dante Controller can be run from any computer in the network. Its serves to route
Dante
TM
inputs and outputs between Dante
TM
compatible devices.
1. Open the Dante Controller Network view .
2. The new Dante
TM
devices from the APS are shown on the screen:
– Dante Receivers:
DICENTIS <hostname server>
–
Dante In 1
– Dante In 2
– Dante Transmitters:
DICENTIS <hostname server>
–
Dante Out 1
– Dante Out 2
– All other devices that are visible on the network are shown as well.
Next, multicast streams need to be created from the transmitters, as the DICENTIS
Conference System utilizes these:
1.
Press Ctrl-D to open the Device info view.
2. Select the device you want to configure to work with DICENTIS.
3. Go to the Transmit tab.
4. Press Ctrl-M to create a multicast flow.
Make sure to select only 1 channel per multicast flow.
5. When the multicast flows have been created, switch back to the Dante Controller
network view to create the connections you want. All successful connections are shown
by a check mark.
For further details on configuring Dante
TM
, refer to the “Dante Controller User Guide”.
14.23 Setting a PIN code for a Dante™ device
To increase security and prevent access from unauthorized parties, a technician should set a
4-digit PIN code to lock each Dante
TM
device in the network.
To set a PIN code for a Dante
TM
device:
1. Open the Dante Controller application
2. Select the Device Info tab
3. In the Device Lock column, left click the row of the device you wish to lock
4. Enter a 4-digit code in the PIN field, and confirm the code in the Confirm PIN field
5. Click the Lock button
P
The PIN code is now set for the Dante
TM
device.