Bosch DICENTIS, Руководство по настройке

Страница: 66 / 134

66 en | Meeting application DICENTIS
2021.06 | V3.7 |
Configuration manual
Bosch Security Systems B.V.
i
Notice!
The horizontal resolution of the PC running the DcnBeamer.bat should be dividable by 8. If
this is not the case, the image can be distorted on the multimedia device and Meeting
Application.
– H.264 stream: Enter the URL of the H.264 presentation source you use, refer to the
documentation of your presentation source (e.g. RTSP://<IP address HD Conference
Dome>). The H.264 stream is packed in RTP stream according to
https://www.rfc-editor.org/info/rfc3984
It can be configured as:
- direct RTP stream (unicast and multicast)
- RTP stream served by an RTSP server (unicast and multicast).
The settings of the H.264 stream are:
‑ 720p25 or 720p30 if multimedia devices are used (or 1080p25 or 1080p30 if only
DCNM-IDESKVID devices are used).
‑ Target bit‑rate 2Mbit/s
‑ Maximum bit-rate 2.5Mbit/s.
‑ GOP length 15 (also known as I-Frame distance).
‑ No B‑frames, I and P frames only.
Refer to
– Installing the image server on a different computer, page 116
5.4.5 Audio settings
– Audio tones: Use the Set… and Remove buttons to upload and remove custom chimes
for Summon and Priority .
Audio file specification:
–
PCM format.
– 16 bits per sample.
– 48 k sample rate.
– Mono.
– Max 700 kb file size.
– Audio tones audible on headphones: When selected, the audio tones are sent to the
headphones of the participants and interpreters. Off by default.
– Mic: Shows the signal of the microphones when they are being spoken in.
– System:
– Master volume : Master volume to control the devices’ loudspeakers and the sound
reinforcement output.
– LSP: Sets the volume for the device loudspeakers in decibel (dB).
– SR: Sets the volume for the sound reinforcement output.
– Change EQ…: Sets the equalizer for both the device’s loudspeaker and the sound
reinforcement output.
– Line, Dante and OMNEO Inputs / Outputs :
– In 1: Sets the sensitivity of Line/Dante
TM
/OMNEO input 1.
– Out 1: Sets the sensitivity of Line output 1.
– Ambient: Sets the ambient audio ON or Off for input 1:
ON : Audio connected to In 1 is only routed to the delegate headphones and the
recorder output when no microphone is active.
Off : (default setting): Audio connected to In 1 is always routed to the delegate
loudspeakers, delegate headphones, and the PA output.