Bosch DHU635GLV, Инструкции по эксплуатации и монтажу

Страница: 8 / 28

8
Cleaning and care
Disconnect the extractor hood from the
electricity supply by pulling out the mains
plug or switching it off at the fuse box.
 At the same time as you clean the
grease filters, clean off any grease from
all accessible parts of the housing. This
significantly reduces the fire hazard and
ensures that the extractor hood performs
as effectively as possible.

Use a hot detergent solution or a mild
window cleaner to clean the canopy of
the extractor hood.
 Do not scrape off any dirt that has dried
on but loosen it up with a damp cloth.

Do not use abrasive cleaning agents or
sponges that could cause scratches.
 Note: Do not use alcohol (spirit) on
plastic parts, otherwise the surface may
become matt in appearance.

Caution: Ensure that the kitchen is
adequately ventilated. Avoid naked
flames!
Clean the switch with a soft, damp cloth
(mild detergent solution) only.
Do not use stainless steel polish on the
sliding switch.
Stainless steel surfaces:.
 Use a mild non-abrasive stainless steel
cleaner.

Clean the surface in the same direction
as it has been ground and polished.
Do not use any of the following to clean
stainless steel surfaces: abrasive sponges,
cleaning agents containing sand, soda, acid
or chloride!
Aluminium and plastic surfaces:
 Use a soft, non-linting window cloth or
micro-fibre cloth.
 Do not use dry cloths.
 Use a mild window cleaning agent.. Do
not use aggressive, acidic or caustic
cleaners.

Do not use abrasive agents.
Replacing the light bulbs
Warning! Prior to touching the light bulbs
ensure they are cooled down.
1.
Switch off the extractor hood and pull out
the mains plug or switch off the electricity
supply at the fuse box.
2.
Remove the grease filters.
3.
Replace the
damaged light and replace it
with a new one
(
see the table below
)
:
4.
Refit the grease filters.
5.
Plug the appliance into the mains or
switch it on at the fuse box.
If you encounter a problem
If you have any questions or if a fault
occurs, please call Customer Service. (See
list of Customer Service representatives).
When you call, please quote the following:
E-Nr. FD
Enter the relevant numbers into the box
above.
The E-Nr. (product no.) and FD (production
date) are shown on the name plate which
can be seen inside the extractor hood after
the filter frame has been detached.
Lamp Power (W) Socket
3 E1
4
Voltage (V) Dimension (mm)
230
55 (Light Center
Length)
ILCOS D Code
(according IEC 61231)
DRGSB/C/UB-3/27/1B-230-E14-55