en
Faults and what to do about them.
24
Information on the display
panel
Faults and what to do about
them.
Display
Cause/remedial action
YES
The washing machine door is unlocked. It is possible to add laundry.
NO
■
Temperature too high. Wait until the temperature drops.
■
Water level too high. Not possible to add laundry. Close the washing machine
door immediately, if necessary. Select
Start
/Reload to continue the pro-
gramme.
NO flashes
■
Wait until
YES
lights up.
F:16
Close the door properly; laundry may become trapped.
F:17
■
Turn the water tap on fully,
■
supply hose kinked or trapped,
■
water pressure too low. Clean the screen.
F:18
■
Detergent solution pump blocked. Clean detergent solution pump.
■
The drain hose/waste pipe is blocked. Clean the drain hose on the siphon.
F:21
Motor fault. Call the after-sales service.
F:23
Water in the base tub, appliance leaking. Call the after-sales service.
E
Childproof lock activated; deactivate it.
N
flashes
Too much foam detected, a rinse cycle has been switched on.
Faults
Cause/remedial action
Water is leaking out.
■
Attach/replace the drainage hose correctly.
■
Tighten the screw connection of the supply hose.
No water supply.
Detergent not dispensed.
■
Start
/Reload not selected?
■
Tap not turned on?
■
Filter blocked? Clean the screen.
■
Supply hose kinked or trapped?
Washing machine door
cannot be opened.
■
Safety function active. Programme stopped?
■
$
(without final spin) selected?
■
Can be opened by emergency release only?
Programme does not
start.
■
Start
/Reload or
Finished in
time selected?
■
Washing machine door closed?
■
E
Childproof lock activated? Deactivate.
Detergent solution is not
drained.
■
$
(without final spin) selected?
■
Clean detergent solution pump.
■
Clean the waste pipe and/or drainage hose.