Bosch BULLS Twenty 6 EVO, Перевод оригинальной инструкции по эксплуатации, Страница: 79 / 116

MY20B01 - 52_1.0_02.10.2019
79
Operation
6.17.3.2 eShift with manual Shimano DI2
hub gears
Only applies to pedelecs with this equipment
The new gear is shown briefly on the display
screen each time it is changed.
Since the drive unit detects the gear shift and
consequently reduces motor assistance briefly, it
is possible to switch gears under load or on hills.
If the pedelec is brought to a halt from a speed
greater than 10 km, the system can automatically
switch back to a pre-set START GEAR.
 Set the START GEAR in the system settings
if necessary.
6.17.3.3 eShift with Shimano DI2 automatic
hub gears
Only applies to pedelecs with this equipment
Since the drive unit detects the gear shift and
consequently reduces motor assistance briefly, it
is possible to switch gears under load or on hills.
 The new gear is shown briefly on the display
screen each time it is changed.
6.17.3.4 eShift with NuVinci H|Sync/enviolo
with Optimized H|Sync
Only applies to pedelecs with this equipment
Setting the desired pedalling frequency
1 Open NUVINCI CADENCE operating mode.
2 Keep the plus or minus button pressed to
increase or reduce the pedalling frequency in
increments of five.
 The desired pedalling frequency will be shown
on the display screen.
Changing transmission
1 Select the NUVINCI GEAR operating mode
2 Use the plus or minus button on the control
panel to switch between different specified
transmissions.

The selected transmission (gear) will be shown
on the display screen.
6.17.3.5 eShift with Rohloff E-14 Speedhub
500/14
Only applies to pedelecs with this equipment
 The new gear is shown briefly on the display
screen each time it is changed.
Since the drive unit detects the gear shift and
consequently reduces motor assistance briefly, it
is possible to switch gears under load or on hills.
If the pedelec is brought to a halt from a speed
greater than 10 km/h, the system can
automatically switch back to a pre-set START
GEAR.

Set the START GEAR in the system settings
if necessary.