Bosch BULLS Twenty 6 EVO, Перевод оригинальной инструкции по эксплуатации, Страница: 43 / 116

MY20B01 - 52_1.0_02.10.2019
43
Assembly
5.3.3.2 Kabolt axle
Only applies to FOX forks with Kabolt axles
The procedure for installing the 15 x 100 mm and
15 x 110 mm Kabolt axles is the same.
1 Place the front wheel in the fork ends of the
fork. Push the Kabolt axle through the fork end
on the non-drive side and hub.
Figure 45: Pushing the Kabolt axle in
2 Tighten the Kabolt axle screw to 17 Nm
(150 in-lb) with a 6 mm hex key.
5.3.4 Checking the stem and handlebars
5.3.4.1 Checking connections
1 Stand in front of the pedelec to check whether
the handlebars, stem and fork steerer are firmly
attached to one another. Clamp the front wheel
between your legs. Grasp the handlebar grips.
2 Try to twist the handlebars towards the front
wheel.
 The stem must not move or twist.
5.3.4.2 Firm hold
1 Place your entire body weight on the
handlebars with the quick release lever closed
to check that the stem is firmly in place.
 The handlebars shaft must not move
downwards in the fork steerer.
2 If the handlebars shaft should move in the fork
steerer, increase the quick release lever
tensioning. To do so, turn the knurled nut
slightly in a clockwise direction with the quick
release lever open.
3 Close the lever and check the stem is firmly in
position.
5.3.4.3 Checking the headset backlash
1 To check the handlebar headset backlash,
close the quick release lever on the stem.
2 Place the fingers of one hand on the upper
headset cup. Pull the front wheel brake with the
other hand and try to push the pedelec
backwards and forwards.
3 The headset cup halves must not move
towards one another while you are doing this.
Note that there may be noticeable backlash
due to worn-out bearing bushes or brake lining
backlash in suspension forks and disc brakes.
4 If there is headset backlash in the steering
headset, you must adjust it as soon as
possible; otherwise, the headset will become
damaged. You must make the adjustment as
described in the stem manual.
5.4 Pedelec sale

Complete Pedelec pass on the operating
instructions envelope.

Note down the battery key manufacturer and
its number.
 Adjust the pedelec to the rider; see Section 6.5 .
 Set the stand and shifter .

Instruct the operator or rider on how to use all
the pedelec's functions.