Bosch BULLS Twenty 6 EVO, Перевод оригинальной инструкции по эксплуатации, Страница: 38 / 116

MY20B01 - 52_1.0_02.10.2019
38
Assembly
5.3 Commissioning
Only trained specialist staff may perform initial
commissioning since initial commissioning of the
pedelec requires special tools and specialist
knowledge.
Experience has shown that a pedelec which has
not yet been sold is automatically handed to
customers as soon as it appears ready to ride.

For this reason, every pedelec must be
prepared, so it is fully ready for use
immediately after being assembled.
 The assembly report (see Section 11.2 )
describes all safety-relevant inspections, tests
and maintenance tasks for the pedelec in a
separate list. All assembly work must be
completed to ensure the pedelec is ready to
ride.
 Complete an assembly report for quality
assurance purposes.
5.3.1 Checking the battery
The battery must be checked before it is charged
for the first time.
1 Press the On-Off button (battery) .
 If none of the LEDs on the battery level
indicator light up, the battery may be damaged.
 The battery may be fully charged if at least one,
but not all, of the LEDs on the battery level
indicator is lit up.
2 Insert charged battery into the pedelec.
5.3.2 Installing the wheel in the Suntour
fork
5.3.2.1 Screw-on axle (15 mm)
Only applies to Suntour forks with 15 mm screw-on axle
1 Insert the axle completely on the drive side.
Figure 26: Fully inserting the axle
2 Tighten the axle to 8–10 Nm with a 5 mm
hexagon socket spanner.
Figure 27: Tightening the axle
3 Insert the securing screw on the non-drive
side.
Figure 28: Pushing the quick release lever into the axle
Burns from hot drive
The drive cooler can become extremely hot
during use. Contact may cause burns.

Leave the drive unit to cool before assembly.
CAUTION
!