Bosch BULLS 650-185, Руководство по эксплуатации

Страница: 177 / 238

176
Maintenance
8.5.8.4 eightpins NGS2 seat post
Only applies to
ebikes
with this equipment
Removing the seat post
1 Use a 2.5 mm hex key to turn the height
adjustment 45°
counter
clockwise and move to
the “Open position”.
Figure 149: Moving height adjustment to the “Open
position”
2 Activate operating lever. Pull seat post
upwards at the same time and remove
completely.
Figure 150: Pulling the seat post out
3 Activate operating lever. Hold cable
fastener and pull or tilt forwards. Remove outer
sleeve from the seat post remote control.
Figure 151: Removing the cartridge
4 Use a 5 mm to undo Postpin axle and pull out.
Figure 152: Undoing the Postpin axle
5 Pull cartridge from the piston rod while pushing
the outer sleeve into the frame at the same
time to help.
Figure 153: Pulling the cartridge out
6 Hold the cartridge with one hand at the height
of the mechanism and pull the cable straight
down with the other.
7 Hold the white actuating slide in the locking
mechanism with your thumb.
8 Carefully push the cable upwards with
the other hand and detach it.
Figure 154: Detaching the cable
Figure 155:
C
able position
Notice
 Never pull cable forwards at an angle.