Bosch BEA 150, Инструкции по ремонту

Страница: 16 / 103

16
4.5.6 O
2
sensor available
4.5.7 O
2
sensor not available
4.5.8 Entering lambda coefficients
OC
V
and HC
V
Open the O
2
sensor available menu using
the
ou
keys and confirm with
E
or by
double-clicking the mouse.
After confirmation that the O
2
sensor is not
available, the measuring chamber's
measuring computer (SI BENCH) is re-
started. After this it jumps back to the
Set
parameters sub menu.
i
The exhaust-gas analyzer is then once
more in the warm-up phase. Further
measurement with the Service soft-
ware is disabled for 60 seconds. A
message appears on screen.
Open the O
2
sensor not available menu
using the ou keys and confirm with E or
by double-clicking the mouse.
After confirmation that the O
2
sensor is not
available, the measuring chamber's
measuring computer (SI BENCH) is re-
started. After this it jumps back to the
Set
parameters sub menu.
i The exhaust-gas analyzer is then once
more in the warm-up phase. Further
measurement with the Service soft-
ware is disabled for 60 seconds. A
message appears on screen.
i Lambda coefficients must also be set
in accordance with regulations speci-
fic to the country of use and must be
stipulated by the law of that country.
Lambda coefficients OC
V
and HC
V
are fuel-specific values and are re-
quired to calculate the lambda value.
Enter the values for OC
V
on the keyboard
and confirm by clicking OK or by press-
ing E .
e.g.: 0.0175.
Enter the values for HC
V
on the keyboard
and confirm by clicking OK or by press-
ing
E .
e.g.: 1.7261.