1 689 989 125
2013-09-09
|
Robert Bosch GmbH
12 | BAT 125 | Maintenance & Troubleshooting
en
5.8
Disposal
This BAT 125 is subject to European guide-
lines 2002/96/EG (WEEE).
Old electrical and electronic devices, includ-
ingcables and accessories or batteries must
be
disposed of separate to household waste.
¶
Please use the return and collection sys-
tems in place for disposal in your area.
¶
Damage to the environment and hazards
to personal health are prevented by prop-
erly disposing of BAT 125.
6. Technical data
Function / Range
Value
Function range
0 °C – 50 °C
32 °F – 122 °F
Accuracy range
0 °C – 40 °C
32 °F – 104 °F
Workplace-related
noise-emission value (Lpa)
< 70 dB(A)
6.1
Battery-Test and Voltmeter
Function / Range
Value
Operating voltage
8 V – 16 V
Operating current without printer
0,4 A
Entry range of Cold Start Current
50 A - 1550 A
Battery standards
CA, CCA, MCA,
DIN, EN, EN2,
IEC, JIS, SAE
6.2
Printer Paper
Function / Range
Value
Maximum storage period by storage in
the dark in years
< 5
Maximum storage temperature
30 °C
86 °F
Maximum storage humidity
<60 %
5.7
Troubleshooting the Printer
!
If the BAT 125 is not connected to a 12-volt battery
with at least 11.5 volts of power or the paper sensor
does not detect paper in the compartment during the
print process
Message
Action to be taken
BATTERY POWER TOO
LOW TO USE PRINT-
ER. CONNECT TO FULLY
CHARGED BATTERY
11.50 TO 16.00V
To print, the tester must be properly
connected to a vehicle battery hav-
ing at least 9 volts.
R
Connect to a vehicle battery with
enough voltage to enable printing.
R
Make sure that the clamps are
connected properly: red clamp to
the positive (+) terminal and the
black clamp to the negative (-) ter-
minal.
R
Check that both sides of the
clamps are making contact with
the terminals.
CONNECT TO
12V BATTERY
Tester is not connected to the bat-
tery
LOW INTERNAL AA BAT-
TERIES. REPLACE AA
BATTERIES SOON!
Internal AA batteries are low and
need to be replaced. See "Mainte-
nance & Troubleshooting" section.
NON 12 VOLT SYSTEM
DETECTED
System being tested is not 12-volts.
PRINTER DOOR OPEN.
CLOSE DOOR AND TRY
TO PRINT AGAIN
Check that the door covering the
printer paper is properly closed and
latched.
PRINTER OUT OF PAPER
REPLACE WITH THERMAL
PRINTER PAPER.
2.5 IN. DIA. MAX
2.25 IN. WIDE MAX
Printer is out of thermal paper.
R
Verify that the paper is inserted
correctly.
R
Insert a new roll of paper.
R
Verify that the paper sensor is
clean and undamaged
QC DATA MEMORY FULL
PRINT RESULTS OR
CLEAR MEMORY.
QC mode memory is full. Select
QC mode from the Options Menu to
clear the memory.
