Bosch AVENAR panel, Системное руководство

Страница: 66 / 76

66 en | Appendix AVENAR panel
2022-07 | 5.0 | F.01U.378.910
System manual
Bosch Sicherheitssysteme GmbH
8 Appendix
8.1 Options with requirements under EN 54‑2:1997/A1:2006
The panel provides the following options with requirements under EN 54‑2:1997/A1:2006:
–
Output for activation of fire alarm devices
– Activation of fire alarm transmission equipment
–
Output to fire alarm transmission equipment
– Alarm acknowledgement input from fire alarm transmission equipment
– Output for activation of fire protection equipment
–
Output type B
– Output type C
– Fault monitoring of fire protection equipment
– Transmission delay
– Dependency of fire detection status on more than one alarm signal
–
Type A dependency
– Type B dependency
– Type C dependency
– Alarm counter
– Fault signal status
–
Fault signals from detection points
– Complete failure of power supply
– Output to fault signaling transmission equipment
– Disabled status
–
Disabling of addressable points
– Test status
– Daymode status
8.2 Controlling Extinguishing Systems
The fire panel enables the activation of extinguishing systems with the extinguishing interface
described in VDE 0833 Part 2 or by the VdS (standard interface SST in line with VdS 2496).
Connection occurs with the FLM-420-RLE-S Extinguishing module.
For each LSN loop, a maximum of 8 extinguishing systems can be activated in each case with
an FLM-420-RLE-S Extinguishing module.
The requirement is for a maximum of one extinguishing area to fail in the case of a system
fault. This means that from the second extinguishing area, there must be a redundant panel
controller.
If several FLM-420-RLE-S Extinguishing modules are used to control the extinguishing system
in each LSN loop, in addition to the redundant panel controller, the associated LSN 0300 A or
LSN 1500 A module must also be duplicated.