68
en | Maintenance – walktest
FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
2020-07 | 3.0 | F.01U.378.877
User Guide
Bosch Sicherheitssysteme GmbH
15.2.2
Ending the walktest
To end the walktest for this walktest group:
1.
Mark the selected walktest group.
2.
Select
Off
.
15.3
Ending walktest for all elements
To end the walktest for all walktest groups and elements:
1.
Select
End
from the status bar.
Various possibilities are offered on the display:
2.
Select
Yes
in order to end the walktest for all walktest groups and elements. Select
No
to
cancel the operation and return to the previous display.
The walktest is ended for all walktest groups.
15.4
Displaying tested or untested elements
Notice!
You can choose to display either the untested or tested elements in the current walktest.
Select
Exit
from the status bar.
The following options are offered for the walktest currently being performed:
–
Select
Not tested
to display the elements that showed no reaction during the test or that
have not been tested.
–
Select
Tested
to display the elements that were tested and showed a reaction.
15.5
Assigning tested elements to a walktest group
Notice!
Only those elements in the current walktest that have been tested can be assigned to a
different walktest group.
On completion of the walktest, you can assign the tested elements to a different walktest
group (for the next walktest, for example):
1.
Select
Exit
from the status bar.
Various possibilities are offered on the display:
Select
Assign tested elements to walktest group
to assign the tested elements from the
current walk test to a walk test group for the next walk test:
A list of the walktest groups is displayed.
2.
Select a walktest group from the list. Refer to
Scrolling through lists, page 25 for
information on how to navigate through a list.
Two possibilities are offered on the display:
–
Select
Add to walktest group
to assign the tested elements from the current walk
test to a selected walk test group.
–
Select
Overwrite walktest group
to replace the elements in the selected walk test
group with the tested elements from the current walk test.
