Bosch AutoDome Junior HD VJR Series, Руководство по эксплуатации

Страница: 58 / 114

5. Click the Installer Menu, located under the Camera link.
6. Click the Open button to the right of View Control to open the View Control window.
Note: The View Control window is disabled 15 minutes after you open the window. If the
View Control window is disabled, you must close the window then re-open to resume
setting the camera position and zoom level.
7. Use the View Control arrow keys and the zoom keys to establish the desired view.
Note: The AutoDome Junior HD fixed camera pans, tilts, and zooms at a much slower rate
compared to a Pan/Tilt/Zoom dome camera.
8. Close the View Control window to set the camera’s position and the zoom level.
9. Click the LIVEPAGE link, in the upper section of the window.
10. To reset the position and zoom level, repeat these steps.
Saving Snapshots
You can save individual images from the video sequence currently shown on the Livepage in
JPEG format on your computer's hard drive. The icon for recording single images is only visible
if the unit is configured to enable this process.
4
Click the icon. The storage location depends on the configuration of the AutoDome Junior
HD.
Recording Video Sequences
You can save sections of the video sequence currently shown on the Livepage on your
computer's hard drive. The icon for recording video sequences is only visible if the unit is
configured to enable this process.
4
Click the icon to start recording. The storage location depends on the configuration of the
AutoDome Junior HD. A red dot in the icon indicates that recording is in progress.
1. Click the icon again to stop recording.
2. To change the storage location for the recorded video, navigate to the Livepage settings
on the Settings page.
Notice!
You can play back saved video sequences using the Player from Bosch Security Systems,
which can be installed from the product CD supplied.
Image Resolution
Sequences are saved at the resolution that has been preset in the configuration for the
encoder (see Basic Mode: Network, page 63).
Processor Load
If the AutoDome Junior IP is accessed via the Web browser, you will see the processor load
indicator in the top left of the window next to the manufacturer's logo.
11.7
11.8
11.9
58 en | Using the IP Interface AutoDome Junior HD Series
2014.11 | 6.1 | F.01U.275.803 Operation Manual Bosch Security Systems, Inc.