Bosch AUTODOME inteox 7000i 2MP, Руководство по установке

Страница: 44 / 66

44 en | Installing the Roof Parapet and Pipe Mounts AUTODOME inteox 7000i - 2MP (pendant)
2020-07 | 1.0 | Installation Manual (pendant) Bosch Security Systems
6. Apply the supplied thread sealant to the threads on the Pipe.
Make sure all surfaces are clean and dry.
Apply a bead of sealant completely around the leading threads of the male fitting.
Force the adhesive into the threads to thoroughly fill all voids.
7. Thread the Pipe Cap onto the down pipe and tighten securely to prevent leaks.
!
Warning!
You must thread the Dome Cap onto the pipe until it is tight. Failure to do so can result in
damage or serious injury or death.
10.5 Wire the Pipe Interface Board
This section provides instructions for connecting wires and cables to the Pipe Interface Board,
as illustrated below. Refer to the
Connection, page 52 chapter for cable and wiring
recommendations and specifications.
BNC
7
5
6
4
3
2
1
2
1
2
1
3
J102
P107
P101
P102
P103
P104
P106
J101
AGND
A7
A6
A5
A4
A3
AGND
OUT 3
OUT 2
OUT 1
1
2
3
4
5
6
P105
Figure 10.6: Pipe Interface Board Connections