10
HOT WATER CONNECTION TO WATER HEATER.
Refer to Technical Sheet for position of connection. The outlet connection is 20 mm (3/4"
BSP) MALE thread, and requires an isolating union to allow for removal of the unit.
Keep the pipe lengths to a minimum, and make sure that the pipework is well insulated as
correct performance of the appliance is dependent on properly insulated pipework.
DO NOT FIT ANY VALVES OR RESTRICTORS TO THE OUTLET OF THE WATER
HEATER.
DO NOT FIT ANY OBSTRUCTION TO THE PRESSURE RELIEF LOCATED ON THE HOT
WATER OUTLET CONNECTION.
After purging the air from the system using the hot water supply taps, remove the water
inlet strainer located on the cold water supply inlet connection. Remove any debris from
the filter and replace. When replacing the filter, do not over-tighten the “O” ring seal.
In order to comply with AS3498 the minimum distances as per the diagram below must be
observed.
These requirements are only for the 50°C locked units.
WARNING: For continued safety of this appliance it must be installed, operated and
maintained in accordance with the manufacture's instructions.
ELECTRICAL CONNECTION
The appliance is equipped with a 1.7 metre cable with a three pinned earthed plug
to be connected to a 240V, 50Hz supply. The electrical rating of the appliance is
0.4 Amps
The appliance requires a 240V in Australia and 230V in New Zealand, 50Hz
weatherproof plug installed in a protected position adjacent to the appliance.
IMPORTANT: The appliance should always be disconnected from the power
supply before any maintenance is carried out.
If the power cord is damaged and
requires replacement, use only an original spare part available from the manufacturer.
Installation/Operating Instructions
Invented for life
COLD
1/2" / 15mm 1.0m (min)
Closest hot water outlet
