English |
23
Material
Application
Application tool
Thumbwheel position
Metal
Removing paint
Sanding sheet
2–3
Metal
Brushing, removing rust
Cup brush, abrasive disc
3
Stainless steel
Grinding
Grinding disc/fibre disc
4–6
Metal
Rough grinding
Grinding disc
6
Metal
Cutting
Cutting disc
6
Stone
Cutting
Diamond cutting disc
6
The values specified for speed levels are guide values.
u
The rated speed of the accessory must be at least
equal to the maximum speed marked on the power
tool.
Accessories running faster than their rated speed
can break and fly apart.
Rechargeable battery
Bosch
sells some cordless power tools without a re-
chargeable battery. You can tell whether a rechargeable bat-
tery is included with the power tool by looking at the pack-
aging.
Charging the battery
u
Use only the chargers listed in the technical data.
Only
these chargers are matched to the lithium-ion battery of
your power tool.
Note:
Lithium-ion rechargeable batteries are supplied par-
tially charged according to international transport regula-
tions. To ensure full rechargeable battery capacity, fully
charge the rechargeable battery before using your tool for
the first time.
Inserting the Battery
Push the charged battery into the battery holder until it
clicks into place.
Removing the Battery
To remove the rechargeable battery, press the battery re-
lease button and pull the battery out.
Do not use force to do
this.
Battery charge indicator
The battery charge indicator indicates the state of charge for
a few seconds when the on/off switch is half or fully pressed.
LED
Capacity
3 × continuous green light
75–100 %
2 × continuous green light
40–75 %
1 × continuous green light
15–40 %
1 × slowly flashing green light
0–15 %
The three LEDs in the battery charge indicator flash quickly
when the temperature of the rechargeable battery is outside
the operating temperature range and/or the overload protec-
tion has been triggered.
Recommendations for Optimal Handling of the
Battery
Protect the battery against moisture and water.
Only store the battery within a temperature range of −20 to
50 °C. Do not leave the battery in your car in the summer, for
example.
A significantly reduced operating time after charging indic-
ates that the battery has deteriorated and must be replaced.
Follow the instructions on correct disposal.
Fitting
Fitting Protective Equipment
u
Remove the battery from the power tool before carry-
ing out work on the power tool (e.g. maintenance,
changing tool, etc.). The battery should also be re-
moved for transport and storage.
There is risk of injury
from unintentionally pressing the on/off switch.
Note:
If the grinding disc breaks during operation or the
holding fixtures on the protective guard/power tool become
damaged, the power tool must be sent to the after-sales ser-
vice immediately; see the "After-Sales Service and Applica-
tion Service" section for addresses.
Protective guard for grinding
Note:
Remove the fitted cover for cutting
(13)
before using
the power tool for grinding (see figure
B
).
Place the protective
guard
(11)
onto the holder
on the power tool until the
coding cams of the protective
guard are aligned with the
holder. When doing so, press
and hold the unlocking
lever
(1)
.
Press the protective
guard
(11)
onto the spindle
collar until the shoulder of
the protective guard is sitting
on the flange of the power
tool and rotate the protective
guard until it audibly clicks
into place.
Adjust the position of the protective guard
(11)
to meet the
requirements of the operation. To do this, push the unlock-
Bosch Power Tools
1 609 92A 75F | (15.02.2022)
