Disconnect 4-input joint from right rear lights and connect with suitable joint in electric bunch:
a) Connect remaining joint of the electric bunch to right rear lights.
Draw end with 4-input and 10-input cube beside side bunch of vehicle to
left rear lights:
a) Disconnect 4-input joint from left rear lights and connect with suitable joint in electric bunch,
b) Connect remaining joint of electric bunch to left rear lights.
Draw remaining part of electric bunch with grey, grey/white and blue/rot leads along the assembled handles in
vehicle rear hatch to left lights on rear hatch:
a) Disconnect 4-input joint from left lights of rear hatch and connect with suitable joint in electric bunch,
b) Connect remaining joint of electric bunch to left lights of rear hatch,
c) Draw remaining part of electric bunch with white lead along the fixed brackets to right lights of rear hatch and
connect as left lights.
Locate 10-input joint behind left side screen in boot.
Additionally in
vehicles with light system control
, connect single-lead bunch with electronic module of the trailer
- use 10-input connection in bunch.
This joint is not used in vehicles with light system control and bridge connection should not be disconnected.
Additional control set of electric installation
art. no. 014-189
Trailer power supply:
Refer to 13-pin version. 3-pin connector housing (red/blue, yellow and white/brown cables) is provided for
expanded socket functions. Put this part of cable set behind the trim. To expand socket functions it is necessary to
order the following parts:
Function ”current supply and earth”
part no. 014-169
Function ”current supply, charge line and earth”
part no. 015-069
Assembly instruction for the customer.
Secure the cable set with supplied cable ties, re-install all trims and other parts which were removed during
installation.
Connect the earth lead to the battery and check all vehicle functions with connected trailer or suitable testing
device.
7.
8.
9.
10.
11.
