Rev. A 15.01.15
OML59002
Page 3
SETUP
1) Inspection
Inspect the UPS upon receipt. Notify the carrier and dealer if
there is damage. The package is recyclable; save it for reuse or
dispose of it properly.
Inspect accessories:
①
Power cable 1PCS
User manual 1PCS
3) Connect the loads
Plug in the AC input cord to the Utility (Make sure the voltage of
Utility matches with the input voltage window of the UPS)
Plug the UPS into the wall outlet to charge the UPS for over 8
hours before using the UPS.
Plug in the loads to output receptacles on the rear panel of the UPS.
Cautio: Do not connect a laser printer to the outlets.
These UPS outlets provide battery power to the equipment when
utility voltage is outside acceptable limits.
4) Connect modem, phone, network for surge protection
(only for the mode with RJ-45)
Connect a single modem/phone line into surge-protected “IN” outlet
on the back panel of the UPS unit.
Connect from “OUT” outlet to the computer with another phone
line cable.
7) Cold start function
When the UPS is off and there is no power utility, it’s still
possible to cold start the UPS unit to power the loads.
5) Connect computer interface port
Connect the optional interface cable to the USB interface port
on the back of the UPS. Connect to the computer. See software
document for installation instruction.
6) Turn ON/OFF the UPS
Turn on the UPS: Press the UPS On/OFF Switch for approx. 3
seconds, then the Buzzer sounds twice, the UPS will be start-up.
Turn off the UPS: Press the UPS On/OFF Switch for approx. 3
seconds, then the Buzzer sounds twice, the UPS will be
shutdown.
2) Choose an installation location
User manual
450VA/650VA/850VA/1000VA/1500VA/2000VA
8) Software download and installation
In the event of blackout and power problems, Borri Power
Guardian software reveals the status of the UPS parameters
including battery capacity and provides, also in your absence,
to shutdown programs, operating system and alerts you via
SMS or email.
Please follow steps below to download and install monitoring
software:
1. Go to the website http://www.borri.it/support
2. Click software icon and then choose your required OS to
download the software.
3. Follow the on-screen instructions to install the software.
4. Restarts your computer.