EN
82
Installation
www.bora.com
9 Installation
Inlet water pressure
The inlet water pressure must be between 200 kPa
(2 bar) and 600 kPa (6 bar).
For Denmark, Finland, Norway and Sweden, the
maximum inlet water pressure must be 1 MPa (10 bar).
O
If the pressure is greater than 600 kPa (6 bar),
a pressure regulator must be installed to ensure
seamless operation.
9.1.4 Waste water connection
O
The water outlet pipe must either be connected to
a surface or flush-mounted trap with a permanent
hose connection, or to the appliance connection
on the sink trap.
O
The waste water temperature can be up to 95°C.
O
The trap must be easily accessible when the
appliance is installed.
O
Only use the water outlet hose provided. There
must be no kinks in the hose and it must not be
shortened or lengthened.
O
The water outlet hose must not be flush-mounted.
9.2
Scope of delivery
X BO scope of delivery
Quantity
X BO steam oven
1
X BO oven rack
1
X BO non-perforated
stainless steel steamer tray
1
X BO perforated stainless steel steamer tray
1
X BO universal tray
1
X BO cleaning cartridge
1
X BO odour filter
1
X BO frame spacer (fitted)
1
Water supply hose
1
Water outlet hose
1
Drain filter
1
Operating and installation instructions
1
Carcass mounting plate
2
Installation templates
1
Tab. 9.1
Scope of delivery
X
Observe all safety and warning information
(see “2 Safety”).
9.1
Installation information
9.1.1 General information
O
Handle recesses are provided at the sides for
carrying the appliance.
O
The installation height of the appliance must be
such that the contents of the food support on the
top shelf level can be seen.
O
To prevent the appliance from shifting or tipping
over, it must be installed inside a fitted unit.
9.1.2 Fitted unit
O
The back panel of the kitchen unit must not be
fitted behind the appliance.
O
To prevent overheating, the appliance must not be
installed behind a decorative door.
O
An unobstructed ventilation cross-section of at
least 160 cm² must be provided in the unit.
O
A minimum distance of 30 mm is to be
maintained between the back of the appliance
and any adjacent structure.
O
Where two X BOs are installed one on top of the
other, a stable built-in shelf or appliance mounting
brackets must be provided for.
O
The appliance must not be installed underneath
a hob.
9.1.3 Fresh water connection
O
The appliance must have a mains water connection.
O
The appliance must be connected to the fresh
water supply (cold water) (3/4” connection thread).
O
The stopcock for the fresh water supply must be
easily accessible when the appliance is installed.
O
Only use the water supply hose provided. There
must be no kinks in the hose and it must not be
shortened, extended or replaced with another hose.
O
The water supply hose must not be flush-mounted.
