bora PKIW1, Инструкции по эксплуатации и монтажу

Страница: 18 / 36

EN
18
Installation
www.bora.com
5.5 Installing the cooktop
INFO Clearance of one millimetre should be planned
between the built-in appliances.
In combination with an adjacent PKA/PKAS
cooktop extractor, the plastic strip on the side
of the cooktop extractor must be carefully
removed for this (see ‘Removing the plastic
strip from the side of the cooktop extractor’).
INFO A clearance of two millimetres should be
planned around the built-in appliances.
INFO A mounting rail should ideally be installed
between adjacent cooktops (PZMS mounting
rail available as an accessory).
INFO Alternatively, the cooktop can be installed with
just one control knob.
INFO Alternatively, the cooktop can be installed
rotated by 180°.
5.5.1 Removing the plastic strip from the
side of the cooktop extractor
INFO The plastic strip on the side of the cooktop
extractor only has to be removed if the
induction glass ceramic wok cooktop is
installed right next to the cooktop extractor.
2
1
Fig. 5.7 Removing the plastic strip from the side of the
cooktop extractor
[1]
Side plastic strip
[2]
Cooktop extractor
5.4.2 Surface mounting
x
B ±2
≤ R5
≥ 74
≥ 74
516 ±2
≥ 700
Fig. 5.5 Cut-out dimensions surface mounting
12
10 - 40
Fig. 5.6 Surface mounting cut-out
Cut-out dimensions when installing cooktops or cooktops
and the cooktop extractor next to each other:
Cooktops/cooktop extractor B in mm
1/0 346
1/1 457
2/1 828
3/2 1310
4/2 1681
Tab. 5.3 Cut-out dimensions appliance combinations surface
mounting