bora PKFI3, Инструкции по эксплуатации и монтажу

Страница: 19 / 36

EN
19
Installation
www.bora.com
5.8.1 Connecting the control knobs
i
Control knobs must only be connected to the ports
provided on the appliance.
1
Fig. 5.19 Back of control knob with port
[1] Port on the back of the control knob
X
Connect the control knobs to the appliances.
Connecting the control knobs to the cooktop
i
In the normal set-up the ports are on the front of the
cooktops.
i
According to the default settings, the left control knob
operates the front cooking zone (zone 1) and the right
control knob operates the rear cooking zone (zone 2).
3 2 1
ZONE1 INTERF. COM1 ZONE2
Fig. 5.20 Ports on the cooktop
[1]
Front cooking zone control knob port (zone 1)
[2]
Extractor electronics interface port
[3] Rear cooking zone control knob port (zone 2)
Securing the cooktop
1
3
2
Fig. 5.18 Mounting brackets
[1] Mounting bracket
[2]
Washer
[3]
Screw
X
Secure the appliance using the mounting brackets [1].
X
Tighten the mounting brackets with the screw [3] using the
washer [2] with max. 2 Nm.
X
Verify that the alignment is correct.
5.7.2 Installation rotated by 180° (alternative
installation variation)
Installation rotated by 180°
X
Rotate the cooktop 180°.
X
For the installation, proceed as described above.
X
Change the installation direction in the configuration menu
(see “Configuration menu”).
i
If installation is rotated by 180°, the ports for the control
knobs and the automatic extractor function are at the
rear of the cooktops.
i
If installation is rotated by 180°, on cooktops PKFI3
and PKI3 the cooktop display is automatically rotated by
180°.
i
Cables of sufficient length are provided.
5.8 Establishing communication and
power connection
X
Observe all safety and warning information (see „2 Safety“).
O
The plug for the mains supply cable must be accessible
following installation.
O
If the mains supply cable has been damaged this must be
replaced.
i
The appliance components are linked by the ribbon cable
provided.