EN
19
Installation
www.bora.com
Connecting the cooktop and the control box
X
X
Create the connection between the cooktop and the
control box.
X
X
Firstly connect the yellow/green earthing cable to the
indicated point on the control box.
Earthing symbol
X
X
Now connect the multi-pin, colour-coded plugs on the
relevant cooking zone to the corresponding colour-
coded sockets on the control box.
5.6 Power connection
X
X
Observe all safety and warning information
(see the Safety chapter).
X
X
Observe all national and regional laws and regulations
as well as the supplementary regulations of the local
utility companies.
INFO
The power connection may only be established
by a certified specialist. He/she also assumes
responsibility for the proper installation and
commissioning.
The power supply line for use (pre-assembled) must be at
least Type H05VV-F or H05VVH2-F.
Q
Q
Cross-section: 3G1.5 mm² with 1-phase connection
Q
Q
If the connection line has been damaged this must be
replaced by a special connection line. This may only
be done by an authorized member of the After Sales
Service team.
Establishing the power connection
X
X
Switch off the main switch/automatic circuit breaker
before connecting the cooktop.
X
X
Protect the main switch/automatic circuit breaker
from being switched on without permission.
X
X
Make sure the device is not energised.
X
X
Only connect the cooktop using a permanent
connection to a power supply cable.
1
L1
2
N
PE
220 - 240 V~
Fig. 5.17 Connection diagram 1-phase
X
X
Create the connection between the cooktop and the
control box.
X
X
Verify that the installation was done correctly.
X
X
Switch on the main switch/automatic circuit breaker.
X
X
Put the cooktop into operation (see the Operation
section).
X
X
Check all the functions are working correctly.
1
2
Fig. 5.15 Cooktop and height adjustment plates
[1]
Cooktop
[2]
Height adjustment plates
X
X
If applicable, insert the height adjustment plate [2].
2
1
Fig. 5.16 Mounting brackets
[1]
Screw
[1]
Mounting bracket
X
X
Fasten the cooktop [1] using the mounting brackets
[2].
X
X
Tighten the mounting bracket screws [1] with max.
10 Nm.
X
X
Verify that the alignment is correct.
X
X
Seal the devices with black heat-resistant silicone
sealing compound after the installation work is
completed.
Содержание PIW 1
Страница 27: ......