bora CI11, Инструкции по эксплуатации и монтажу

Страница: 17 / 28

EN
17
Installation
www.bora.com
5.5 Installing the cooktop
INFO A gap of one millimetre should be planned
between the built-in appliances.
INFO A gap of two millimetres should be planned
around the built-in appliances.
INFO Cable protection (a false floor) should be
mounted below the devices. This needs to be
removable for maintenance work.
>
20 50
Fig. 5.8 Side view of the cable protection and ventilation
Q Q
Cross bars on the unit in the area of the worktop cut-
out may need to be removed.
Q Q
Make sure that the area below the cooktop is suffici-
ently ventilated. An opening cross-section > 50 cm
2
at
the front side and in the intermediate bottom for the
ventilation of the induction equipment should be
available.
Q Q
The drawers and/or shelves in the floor unit must be
removable for maintenance and cleaning purposes.
5.5.1 Installing the cooktop
1 2
Fig. 5.9 Built-in cooktop with cooktop extractor
Attaching the sealing tape
1
2
Fig. 5.6 Sealing tape, flush installation
[1]
Black heat-resistant silicone sealing compound
[2]
Sealing tape
2
1
Fig. 5.7 Sealing tape with surface installation
[1]
Black heat-resistant silicone sealing compound
[2]
Sealing tape
X X
With surface installation, attach the enclosed sealing
tape [2], on the underside of the device before instal-
ling it. Do not leave any gaps.
X X
With flush installation, attach the enclosed sealing
tape to the horizontal cutting edge in the worktop cut-
out, even if you seal the cooktop with a silicone
sealing compound [1] or similar.
X X
Note down the type designation and build number of
the device (FD number) on the back of this manual.
Both designations can be found on the nameplate on
the underside of the device.