bora BHA, Инструкция по эксплуатации и сборке

Страница: 28 / 44

EN
28
Assembly
www.bora.com
1
L1 L2 L3
2 3 4
N PE
220 - 240 V~
220 - 240 V~
220 - 240 V~
Fig. 6.35 Connection diagram 3-phase connection
1
L1 L2
2 3 4
N PE
220 - 240 V~
220 - 240 V~
Fig. 6.36 Connection diagram 2-phase connection
1
L1
2 3 4
N PE
220 - 240 V~
Fig. 6.37 Connection diagram 1-phase connection
3
3
1
1
2
Fig. 6.38 Electrical connections of the cooktop
[1]
Bore holes
[2]
Power supply
[3]
Cable mounting clip
X X
Connect the exhaust air duct [7] installed on-site to the
exhaust air arc [6].
X X
Seal the duct connection so that it is airtight using
adhesive sealing tape UDB1.
X X
Fasten the cooktop using the mounting brackets [8] at
the worktop.
X X
Afterwards, insert the stainless steel grease filter [4]
and air inlet nozzle [3].
X X
Seal the surrounding gap with a black heat-resistant
silicone sealing compound.
6.8 Establishing the power
connection
X X
Observe all safety and warning information (see Safety
chapter).
X X
Observe all national and regional laws and regulations
as well as the supplementary regulations of the local
utility companies.
INFO The power connection must only be implemented
by a certified engineer. He/she also assumes
responsibility for the proper installation and
commissioning.
INFO Connection via plug-in contacts, e.g. plugs with
earthing contacts, are not allowed.
X X
Switch off the main switch/automatic circuit breaker
before connecting the cooktop.
X X
Protect the main switch/automatic circuit breaker
from being switched on without permission.
X X
Make sure the device is not energised.
X X
Only connect the cooktop using a permanent
connection to a type H 05 VV-F power supply line
with appropriate minimum cross section (s. Tab. Fuse
protection and minimum cross section).
Connection Fuse protection Minimum
cross-section
Three-phase-connection 3 x 16 A 2.5 mm
2
Two-phase-connection 2 x 16 A 2.5 mm
2
One-phase-connection 1 x 32 A 4 mm
2
Tab. 6.2 Fuse protection and minimum cross section