•
•
DUOTRAP S
ANT+ and Bluetooth Smart Dual Mode
Integrated Speed and Cadence Sensor
•
1
•
2
•
4
•
5
•
1
•
•
2
4
•
1
m
2.5N
MADE IN CHINA
•
3
•
6
m
2.5N
•
CR20
32
a
b
•
3
•
2
5
4
4
a
b
SENSOR INSTALLATION (ALLOY BIKES)
SENSOR INSTALLATION (CARBON BIKES)
BATTERY INSTALLATION AND REPLACEMENT
Gasket (alloy bikes)
Remove DuoTrap S cover
from chainstay.
Remove DuoTrap S cover
from chainstay.
Medium cadence
magnet band
(crank)
Install sensor into chainstay.
While holding sensor in
place, use a 2.5mm hex to
tighten
6mm short screw
.
Note: 6mm screw must be
used with carbon frames.
Remove grommet and
replace with gasket in #3.
Remove grommet.
Hold sensor into place and
install
8mm long screw
.
Install sensor into grommet in the chainstay. Hint: Hold
grommet in place with one hand while inserting sensor with
the other as seen in pic 4a and 4 b.
Replacement battery
CR2032.
Use a coin to close battery
compartment.
Install gasket onto sensor
with notch aligned with
screw hole as depicted
Fully insert grommet into
chainstay resulting in a flush
connection with chainstay.
While holding sensor in
place, use a 2.5mm hex to
tighten
8mm long screw
.
Sensor with grommet (carbon bikes)
8mm alloy
bike mounting
screw
6mm carbon
bike mounting
screw
Small cadence
magnet band
(crank)
Large cadence
magnet band
(crank)
CR2032
battery
Alloy bike speed
magnet (wheel)
Cadence band
shim (optional)
Carbon bike speed
magnet (wheel)
