Page 5
3B-390953NI – 01/17
BONNET GRANDE CUISINE
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
8
PARAMETER ADJUSTMENT
8.1
FACIA
- Press the « Cleaning/Tool » button .
- Scroll through the parameters until you get to installation: « inSt » using the coder of the
/
buttons.
- Select the « inSt » parameter button
- Enter the PIN code for the installer « inSb »:
* The first digit appears in cyan and flashes. Using the coder or the
/
buttons allows you to change the value of the first digit.
* Once the value is correct pressing the coder or the « PROG/VALID » button moves you on to the next digit which can be altered in the
same way
* When all the code has been entered and it is correct access the menu or start on the PIN number again.
Frequency of maintenance, level of use per day and temperature display parameter
- Enter the number of hours before the next service visit (1500 hours by default): « HSr ». Adjustable from 0 to 5000 hours. Allow at least one
service per year.
* Select the value to be modified
* Adjust the setting using the coder or the
/
buttons.
* Once adjusted press the coder or the “PROG/VALID” button allows you to pass to the next parameter.
- Enter the average hours per day that the unit is likely to operate for: « H-d ». Adjustable from 1 to 24 hours.
* Select the value to be modified
* Adjust the value using the coder or the
/
buttons.
* Once adjusted press the coder or the “PROG/VALID” button allows you to pass to the next parameter.
- If required change the temperature display parameter setting « tEMP ». 3 possibilities: « Ta »: displays Ambient Temperature, « TC »: displays
the Set Temperature, « dEF »: Default display.
* Select the value to be modified
* Adjust the value using the coder or the
/
buttons.
* Once adjusted press the coder or the “PROG/VALID” button allows you to pass to the next parameter.
8.2
WATER TREATMENT COUNTER
This only functions if there are 2 separate supplies to the oven.
- Press the “Cleaning/Tool” button.
- Scroll through the parameters until Client parameters: « CHEF » using the coder or the
/
buttons.
- Select the « CHEF » parameter button
- Enter the PIN code for the client « CHEF »:
* The first digit appears in cyan and flashes. Using the coder or the
/
buttons allows you to change the value of the first digit.
* Once the value is correct press the coder or the « PROG/VALID » button moves you on to the next digit which can be altered in the
same way
* When all the code has been entered and it is correct access the menu or start on the PIN number again.
- Scroll through the parameters until the « EAu CAPA » menu, using the coder or the
/
buttons.
- Select « EAu » to access the water treatment counter sub menu
Water treatment capacity
- Modify or check the water treatment capacity (in litres). Set to zero by default (if there is not a dedicated water treatment system for the oven).
* Select the value to be modified
* Adjust using the coder or the
/
buttons.
* Once the value is set press the coder or » PROG/VALID » to validate the setting.
- Reset the counter if required.
* Move to the next parameter using the coder or the
/
buttons.
* Press « YES » below the « Rst » button
