AHD-WNL Monitoring & Control with iPad
®
Integration
Installation and Initial Startup
68
V1
7.4 Installation
CAUTION!
Equipment damage from insufficient cooling!
The heat generated by the
industrial PC’s high power
consumption can damage the industrial PC or other
devices and cause system errors.
Therefore:
– Only install the devices in housings/panels with
air vents.
– Select an installation depth that allows an air
current to circulate for cooling the devices.
– During installation, ensure that no other devices
or materials, such as cables, will be damaged
by the heat generated.
AHD-WNL and other possible devices, such as an AHD-DPU 9,
are installed in suitable locations that are protected specifically
from water, dust, and shock.
TIP!
When installing the devices, ensure that their inter-
faces can be accessed during installation and sub-
sequent maintenance tasks.
7.5 Connection to an AHD-DPU 9
Connect the AHD-DPU
9’s LAN port to AHD-WNL’s LAN1 port with
an Ethernet cable.
The other ports, inputs and outputs of the AHD-DPU 9 are used for
communicating with the
ship’s devices and bus system. Their utili-
zation is project-dependent; the connections can be found in the
project documentation.
The Ethernet ca
bles’ maximum length can be 100 m.
7.6 Connection to a Panel PC AHD 12XX
When connecting the device to a Panel PC AHD 12XX, the
AHD-WNL
’s LAN1 port is connected to the Panel PC’s LAN1 port.
7.7
Connection to the Ship’s Network
Connect the AHD-WNL
’s LAN2 port to the ship’s network with an
Ethernet cable.
