Bongiovi Acoustics Clear 360 Pro, Руководство пользователя

Страница: 11 / 24

11
6. WING AND FOAM FITTING
1. Attach the
Medium
size Ear Wings to the Ear Piece by pressing it onto
the base of the post. When installed correctly, the wing will lock onto
the tabs on the Ear Piece and will not be able to rotate.
( See “5.1
Attaching Ear Wings” )
2. Attach the
Large
size Foam Ear Tips to the Ear Piece by inserting the
post on the Ear Piece into the center of the Foam Ear Tip. Press firmly
until the post is fully inserted into the middle of the Foam Ear Tip as
deep as possible.
(See “5.2 Attaching Foam Ear Tips”)
3. Press and roll the Foam Ear Tip between your thumb and forefinger
until the foam is fully compressed to the smallest possible size.
4. Position the Ear Piece so that the rounded part of the Ear Wing is
facing upward and the front of the Ear Piece is facing the ground.
Insert the Foam Ear Tip into your ear canal as deeply as is comfortable.
5. Rotate the Ear Piece backward in your ear until the wing is fully seated
inside the fold of your ear. Note: You may need to press on the wing
with your finger to install it fully.
6. The Ear Piece will look like the picture to the left when it is inserted
properly. The Ear Wing will be fully seated into the fold of the ear,
and the Ear Piece will be parallel to the ground with the wire exiting
near the front.
7. Test for proper fit with the unit powered off. Loudly clap your hands
next to your ear and listen to the sound level. If the Foam Ear Tips are
the correct size and properly inserted, all outside sound should be
significantly muted. If not, repeat all steps and follow the
troubleshooting guide that follows.