GSF2818KS
Owner’s Manual
15
3. Open cylinder valve.
Push the side burner valve knob and rotate slowly about 1/4 counterclockwise until a click is heard. The burner should be
lit. If the burner does not light, repeat 2 or 3 more times. If ignition does NOT occur in 5 seconds turn the burner controls to
OFF, wait 5 minutes, and repeat the lighting procedure.
4. Adjust valve knob to the desired cooking temperature.
Using the Lighting Stick to Light the Side Burner
1. Open lid while lighting the burner. Lid must remain open while burner is lit
2. Remove the lighting stick then insert a match into the end of lighting stick.
Light the match.
3. Once lit, place the flame to reach the burner ports. (See diagram to upper right.)
4. Press the control knob and rotate it counterclockwise to the ‘’HIGH’’position. The burner should light immediately.
5. Adjust burner to the desired cooking temperature.
Observe flame height when lit:
Flame should be a blue/yellow color between
1 to 2 inches high.
Confirm that the burner is properly lit and that the flame pattern is as desired (see fig. A, B and C below for the proper flame
patterns). If the flame pattern is other than normal, consult the
Troubleshooting
on page 21 for corrective action.
FIG. A FIG. B FIG. C
Burner installation and adjustment
Lighting Infrared Burner
1. Open lid while lighting burner.
2. Make sure the control knob is locked in the OFF position.
3. Open
cylinder
valve.
4. Push and turn control knob to HIGH setting. After lighting, please observe the ceramic plate on the surface of burner; it
should feel warm after 5-10 seconds and the color of the ceramic plate should turn red in 2-3 minutes.
5. If burner does not light on the first try, turn the control knob to its OFF position and wait 5 minutes for gas to clear before
trying again. If burner flame goes out during operation, immediately turn the gas OFF and open lid to let the gas clear for
about 5 minutes. Attempt to re-light.
2 in.
1 in.
0 in.
Normal: Soft blue flames with yellow
tips between I inch - 2 inches high.
Out of adjustment: Noisy hard blue
flames – too much air.
Poor combustion: Wavy, yellow
flames- too little air.
1. Release the screw on venturi tube.
2. Adjust the flame by turning the collar
on head of venturi tube from back side
of the grill and do not take apart the
venturi tube.
3. Tighten the screw and make certain it
is secured.
1. Overlap 14 mm between
venturi tube and nozzle
when assembling.
2. Keep the center line of venturi tube
and nozzle on one line.
End edge should face towards upside.