Bona FlexiSand
9
The operation of Bona FlexiSand is subject to applicable national regulations.
Beyond the user manual and the applicable rules for the country for preventing accidents, the applicable
technical trade provisions for safety and professional work methods must be followed. Work methods that
can set safety out of focus may not occur.
Normal use
Bona FlexiSand is only intended for indoor use at temperatures b10°C (50°F) and +35°C (95°F)
and in good lighting.
If it is used in any other manner, this is against applicable provisions.
When you work with the machine, be observant of the surroundings and particularly persons nearby. Do
not use the machine around children. The manufacturer is not responsible for injuries that occur via such
use. In this case, the user assumes full risk. In addition to the normal usage instructions, the
manufacturer's care and maintenance instructions must also be followed.
The manufacturer is not liable for any damage to the machine resulting from prohibited changes.
The manufacturer is not liable for damage to the machine or to the floor covering to be sanded.
Warning! The machine is only intended for work on level surfaces with a maximum slope of 2%.
Warning! The machine is not intended for pure concrete sanding.
Warning! Never run the machine over power cables. Danger of short circuit.
The user is expressly obliged only to use the machine in accordance with this manual. If the machine is
used in any other manner, this is solely at the user’s own risk. The manufacturer’s liability ceases fully in
this case.
The machine may not be used in areas where explosive or flammable substances are stored or
manufactured (such as petrol, thinners, fuel oil, solvents, etc.).
The machine's electrical components and mechanical parts can cause these substances to ignite.
Never work with worn, damaged or incorrect equipment, which can cause damage to the floor.
Always use earth fault breaker!
The power cable with extension may not exceed 10 m!
Risks
When the machine is not in use, the power cable must be disconnected from the wall socket in order to
prevent damage to the floor and unlawful use.
For transport in lifts, the applicable user and safety instructions must be followed, especially where load
capacity is concerned.
In order to prevent unauthorized use of the machine, it must always be stored in a suitable location.
Regularly check the power cable and the machine for wear or aging.
