58
PRE-OPERATION CHECKS
Some of the following items may not
have been previously covered in this
guide, however they will be described
in the MAINTENANCE or SPECIAL
PROCEDURES section. Please refer
to these portions to have more de-
tailed information.
SUMMARY
WARNING
The pre-operation check is very
important prior to operating the
vehicle. Always check the proper
operation of critical controls, safe-
ty features and mechanical com-
ponents before starting. If not
done as specified here, severe in-
jury or death might occur. Bring all
safety equipment required by lo-
cal laws.
WARNING
Engines should be off and the
safety lanyard must always be re-
moved from its switch prior to ver-
ifying any of the following. Only
start craft once all items have been
checked and operate properly.
ITEM
OPERATION
✓
Hull
Inspect.
Jet pump water intakes
Inspect/clean.
Bilge
Drain. Ensure plug is secured.
Battery
Inspect tightness of cables and retaining straps.
Main battery cut-off switch
Ensure it is in the ON position.
Navigation lights
Check operation.
Fuel tank/engine oil (P/S)
Refill.
Engine compartment
Verify fuel/oil system components.
Fire extinguisher
Inspect condition/mounting.
Steering
Check operation.
Throttle/shifter system
Check operation.
ICS (Inlet Clearance System)
Ensure it is not activated.
Bilge blower and bilge pump
Check operation.
Safety lanyard/engine start/stop
buttons
Check operation.
Mandatory safety boating
equipment
Check operation.
Storage compartment covers
Ensure they are closed and latched.
Engine Coolant (anti-freeze)
Ensure proper level is in each engine.
lmo2004_002a.book Page 58 Wednesday, May 14, 2003 11:10 AM
Содержание SeaDoo Speedster 200
