BOMBARDIER SEA-DOO GS 5626 1998, Руководство по ремонту

Страница: 319 / 426

Section 10 STEERING SYSTEM
Subsection 02 (SPX MODEL)
10-02-2
REMOVAL AND INSTALLATION
1, Cover
To replace the cover, loosen set screws no. 19 of
handlebar housing.
1. Set screw
Remove and reinstall 4 screws no. 2 and washers
no. 3 .
1. Cover
2. Screws
4,8, Grip and Grip Insert
To remove grip, just pull out cap no. 5 from grip
end and remove screw no. 6 and washer no. 7 .
Pull out grip.
To verify grip insert for damage, remove it from
handlebar.
When installing the grip insert in the handlebar
no. 12 , ensure that its notch is properly inserted
in the hole beneath the handlebar.
Install grip no. 4 on handlebar no. 12 matching it
to the hex form on the grip insert.
Install flat washer no. 7 and screw no. 6 .
Torque screw to 13 N•m (10 lbf•ft).
Install cap no. 5 .
1. Grip insert
2. Grip
3. Flat washer
4. Screw. Torque to 13 N•m (10 lbf•ft)
5. Cap
9,12, Steering Stem and Handlebar
Disconnect wiring harnesses leading out of steer-
ing stem
no. 9 .
Disconnect throttle cable at carburetor.
Remove throttle cable from tie-blocks.
Unscrew bolts no. 16 retaining support no. 11 to
steering stem arm no. 10 .
F00K01A
1
F00K02A
2
1
-
CAUTION
Ensure to install flat washer otherwise screw
will damage grip end.
F01K1PA
1
2
3
4
5