82
– the seal on the throttle cable.
Remove the carburetor side cover.
Install the cable luber (P/N 529 035 738)
on the cable.
Insert the needle of lubricant can on
the cable luber hole.
NOTE:
Place a rag around the cable lu-
ber to prevent the lubricant splash.
Put the lubricant until it passes through
the cable.
Reinstall and adjust the cable.
Throttle Lever Adjustment
Slide rubber protector back to expose
throttle cable adjuster.
Loosen lock nut then turn the adjuster
to obtain correct throttle lever free play.
NOTE:
Measure throttle free play at
the tip of throttle lever.
Tighten lock nut and reinstall protector.
1. Throttle lever
2. Protector
3. Cable adjuster
4. Lock nut
A. 3 to 6 mm (1/8 to 7/32 in)
Suspension
Lubrication
Lubricate front A-arms. Use synthetic
grease (P/N 293 550 010). There is two
grease fittings on the upper A-arm and
two on the lower A-arm (underneath).
WARNING
Always wear eye protection and
gloves when you lubricate a cable.
V00I02Y
V00I03Y
1
V04I02Y
2 3 4
A
vmo2002_004a.book Page 82 Friday, August 3, 2001 10:27 AM
Содержание Quest 500 2002
Страница 1: ......
Страница 46: ...44 Label 8 Label 9 Label 10 Label 11 Label 12 V04M07Y V01M09Z V01M0BZ V04M08Y V04M0AL...
Страница 100: ......