BOMANN VSE 228.1, Инструкция по эксплуатации

Страница: 17 / 24

17
•
Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
•
Connect the mains cable to a properly installed
and earthed wall outlet.
•
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the
Reverse the Reverse the
Reverse the door o
door o door o
door opening
pening pening
pening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
WARNING: WARNING:
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply. Always unplug
the appliance first.
NOTE NOTE NOTE NOTE::::
•
When installing, ask another person to assist.
•
You possibly need:
screw wrench, Phillips screw-
driver as well as a thin-blade screwdriver.
•
Dismount the upper limit plate incl. hinge pin by
loosening the screws. Open the door a little and
take it carefully off the lower door hinge. Place the
door on a padded surface to prevent it from
scratches.
•
Tilt the appliance slightly backwards and block it
in this position. Loosen the lower hinge pin and
put it in the opposite bracket.
•
Replace the appliance upright again. Insert the
appliance door on the lower hinge pin and fix the
door to the property position.
•
Attach the upper limit plate after you have un-
screwed the hinge pin and used it on the other
side of the plate. Insert the hinge pin in the hole of
the appliance door and tight the plate.
•
Check if the door is arranged vertical as well as
horizontal, so that a smooth opening and closing
of the door is ensured.
Built Built Built Built----in in in in
Built-in openings
Height x Width x Depth
872–880 x
560–570 x 550 mm
Figures in mm
For the appropriate venting an exhaust duct of
approx. 50 mm depth is to provide at the appliance
back.
The ventilation openings in the furniture base and
building must be min. 200 cm
2
to ensure that heated
air can freely escape.
Install the power cord so that the appli-
ance can be easily connected after
installation. Slide the appliance into the
build-in opening until the stop plate (A)
abuts the furniture.
Press the rubber seal between the
appliance and built-in furniture firmly
(on the side without hinge).
Open the appliance door. Push the
appliance side, which is located oppo-
site the hinges, against the built-in
furniture. Arrange the appliance for a
secure, vertical position, fix it with the
supplied screws and put the protective
cap (B) on.
Separate the parts b, c and d of part a.