BOMANN KGE 7808.1, Инструкция по эксплуатации

Страница: 22 / 32

22
Mounting material
(R) 1x seal (a) 4x guide (b) 4x bracket (c) 4x cover (d) 4x cover
(S1) 27x screws (S2) 2x screws (M) 2x cover
1 2 3
4 5 6 7
8 9
CAUTION:
Before drilling, check the furniture front for sufficient
strength for the enclosed screw length.
1
Install the power cord so that the appliance can
be easily connected after installation. Slide the
appliance into the build-in opening until the stop
plate (A) abuts the furniture.
2 Press the rubber seal between the appliance and
built-in furniture firmly (on the side without hinge).
3 Open the appliance door. Push the appliance
side, which is located opposite the hinges, against
the built-in furniture. Arrange the appliance for a
secure, vertical position, fix it with the supplied
screws, bottom 2x (S2) and top 2x (S1).
4 In consideration of the shown distances, hold the
guide (a) at the top and bottom inside of the furni-
ture door; mark the positions of the drill holes. Af-
ter drilling, fix the guide with the screws (S1) pro-
vided.
5
Insert the cover (c) until it clicks in the guide (a).
6 Fully open the appliance and furniture door and
join them together. Slide the angle (b) in the guide
(a) and mark the drill holes. Remove the bracket
and drill Ø 2 mm holes with about 8 mm distance
to the outer door edge. Put the bracket on again;
secure it with the screws (S1) provided.
7 If an aligning of the furniture door is necessary,
use the slot spacing. Check if the door is ar-
ranged vertical as well as horizontal, so that a
smooth opening and closing of the door is en-
sured.
8 Insert the cover (b) until it clicks on the angle (b).
9 Fix the bracket angle of the center door hinge with
the kitchen furniture using the enclosed screws