OUTDOOR PIR MOTION SENSOR
INSTALLATION AND OPERATING INSTRUCTIONS
Model WS-103S
For use with the BOLTEK Home Protection System
Please keep this user guide in a safe place for future reference.
Kit contents:
1 x PIR Motion Sensor
1 x Magnet mounting bracket
2 x Screws and wall plugs
1 x User guide
1. Introduction
The PIR Motion Sensor is designed to trigger the BOLTEK Home Protection System when
it senses movement in given area.
2. Location
First determine the location of the Sensor, which should be placed:
• on a solid surface between 1.8m to 2.4m (6ft to 8ft) from the floor.
• near key entry/exit points.
• away from extreme temperature sources (radiators, ovens, stoves etc.) and large metal objects
that could interfere with the wireless performance.
• away from direct sunlight.
• indoors only and not behind partitions.
• where better RF performance can be achieved (if necessary).
IMPORTANT! The Motion Sensor is immune to pets moving on the floor or climbing on furniture as long
as the activity takes place below 1m (3ft). Above the 1m (3ft) height limit, adjust the sensitivity of Motion
Sensor to “Middle” or “Low” position so more movement is required to trigger the sensor but the pet
immunity will decrease as the pets get closer the sensor. It is important to perform a “Walk Test”
(Described in part 3.5) with your pets.
3. Installation and Operation
3.1 Tamper Protection
The PIR motion sensor has a built-in tamper proof switch to prevent
the sensor being disabled by an intruder(Fig.1).
• Before powering up and installing the Motion sensor, ensure the
system is in standby mode to avoid the alarm sounding.
• The Tamper Proof protection is enabled once the Smart Panel is
switched to HOME, ALERT or ARM mode. The panel will be
triggered with Ding Dong sound or alarm sound under different
modes once the main motion transmitter being taken away.
Fig. 1 Tamperproof Protection
WS103S PIR Motion Sensor
Magnet mounting bracket
PIR Motion Sensor
. 1 .
