Bolin Technology 2 Series, Руководство пользователя

Страница: 31 / 36

31
To reset the setting
To reset the setting, press the 1 (STD) button while holding down the L/R DIRECTION SET button.
Arrow button Movement of the
camera
Setting
While holding
down
Press
Note
The above setting only changes the signal emitted from the infrared remote controller, and does not change the setting of
the camera itself. Therefore, repeat the setting for each infrared remote controller if you are using more than one infrared
remote controller.
When the STANDBY lamp is blinking
If the camera is moved forcibly, or a finger or other object interferes with camera movement, the camera may fail to
memorize the pan/tilt position.
Press the PAN-TILT RESET button to reset the pan/tilt position.
Zooming
Button [T] - Zoom-IN and [W] - Zoom-OUT.
Button [F] – FAST mode.
Press once and the LED turns red to activate the Fast Zoom Speed Mode,
press again to go back to normal Zoom Speed mode.
Operating Multiple Cameras with the Infrared Remote Controller
1. Set the DIP Switch on the bottom of the camera to the number of camera you want to operate to 1, 2 or 3.
(See bottom DIP Switch setting instruction)
2. Press the CAMERA SELECT button on the infrared remote controller that
corresponds to the number set in step
Then, you can operate the camera(s) specified by number. Every time you operate the camera(s) using the infrared remote
controller, the CAMERA SELECT button pressed in step 2 lights.
Adjusting the Camera
Focusing on a Subject
Focusing the camera on a subject automatically
Press the AUTO button.
The camera focuses on the subject at the center of the screen
automatically.
Focusing the camera on a subject manually
After pressing the MANUAL button, press either the FAR or the NEAR
button to have the camera focus on the subject.
Shooting with Back Lighting