Boley FT009, Руководство пользователя

Страница: 1 / 3

-1-
-2- -3-
Top Boat Cover
Middle Boat Cover
Boat Cover
Lock Latch
AGE 14+
Operating Instructions for 2.4G Wireless
Remote Control Boat
Main Structures of Remote Control Boat
Upper Boat Cover
Middle Boat Cover
Housing Cover
Screw Propeller
Display Stand
Steering Knob
Power Switch
Power LED Light
Flip Cover
Throttle
Fine-Adjustment
Knob
Frequency LED Light
Directional
Fine-Adjustment
Knob
Throttle Control Trigger
Tail Vane
Steering
Draw Bar
Boat Cover
Lock Latch
Remote Controller Battery Installation
Rechargeable battery
1.5V AA x 6 batteries
(Batteries not included)
Racing Boat Battery Installation
Frequency pairing for remote controller and boat model
1.Twist the lock latch to remove the top and
middle boat cover.
3. Connect the the Li-ion battery pack to the
circuit board in the body of the boat.
2.Place Li-ion battery pack in the battery
holder of the boat body.
4.Place the top and middle cover back onto
the boat and twist the lock latch until all
pieces are locked in place.
Install the battery, place the boat on the water and turn on the remote controller. When
the red light is solid and the green light is flashing, it means that the boat is pairing with the remote.
When the green light turns solid, the boat and the remote have successfully paired. The pairing
process should take no more than 5 seconds
.
Caution about Batteries, USB Charger
Note:
If over 5 seconds, the pairing was unsuccessful.
Before charging the lithium battery
pack, make sure the battery is fully
dried and has had 30 minutes to cool
down after use.
Attention
ʽ
ATTENTION:
Please read all warnings and instructions carefully before using this product.
FT009
1.Driving system is equiped with 540 high-power main motor, high-precision
servo control steering system, and water cooling system motor.
2.Includes a high power rechargeable Lithium-ion battery.
3.The boat has a max speed of 30 kilometers per hour.
4.Boat Dimensions:
Length of boat body: 463mm
Width of boat body: 124mm
Height of boat body: 118mm
Batteries: Open the battery cover of the remote controller. Put 1.5V AA x 6 batteries in the remote according to
positive and negative electrodes. Close the battery cover and tighten the screws (See Figure1).
Properly connect the 7.1V lithium battery pack to the end of the USB charging cable connector until you hear a click. Plug the
USB charging cable into any USB power socket. Allow 5 hours for the lithium battery pack to be fully charged. Once charged,
disconnect the USB charging cable and the lithium battery pack. Always store the battery pack in a cool place away from
excessive heat.
1.1.5V AA battery X 6 for remote control.
7.4V/1500mAh lithium rechargeable battery pack for high
speed racing boat.
2.Install and remove batteries according to intstructions.
3.Do not charge non-rechargeable batteries.
4.Remove batteries from the boat before charging.
5.Do not mix batteries of different types or use old and new
batteries together.
6.Batteries should be installed in right polarity.
7.Exhausted batteries must be removed from toy.
8.No short circuit of power-line connection is permitted.
9.Please only use the provided USB charging cable.
10. Please cut off power of USB charging cable before using
any liquid to clean the boat.
11.Regulary check for damages to wires and batteries to
ensure consistent safety when the toy is being operated.
USB Charging Cable
Battery Pack
(7.4V/1500 mAh High Power
Rechargeable Li-ion Battery)