Step 2
Step 3
Start the base frame by taking one of the
Part A pieces (holes
do not
go through end
piece) and setting it with the holes facing
up as shown. Add a Part B piece as shown
and insert the Pin (C) to hold it in place.
Unfold the fabric liner (E) and locate the
two cutouts on each of the long sides. Take
one Drag Beam (D) and insert the end of it
through the
bottom cutout
of the fabric.
Line it up on the hole of the Part A piece
and insert Pin C as shown. Repeat for the
other side, being sure to slot the Drag
Beam (D) through the
bottom cutout
of the
fabric.
Take another Part A piece, fit it under the
open end of the Part B piece, and slide the
Pin (C) in as shown.
Step 1
A
B
A
B
B
C
C
E
C
A
(A) - 6pcs
Pin (C) - 6pcs
(B) - 6pcs
Drag Beam (D) - 2pcs
Fabric Liner
(E) - 1pcs
Thank you
Thank you and we hope you enjoy your planter bed! We truly believe people should be
outside and we hope this planter bed helps you do that.
Wooden Raised Planter Bed (BGRBD30)
Assembly Guide
We recommend positioning your raised bed on a level surface for best
results and to avoid gaps where the wood panels come together. If
needed, you can dig out the ground on the high spots to properly level
the planter.
Tip
If you have any problems with your product or questions during
assembly, please reach out to [email protected] before
returning it to your place of purchase.
Need Help?
Assembly Instructions
Box Contents
Holes do
not go
through
end piece
Holes go
through
end piece
Top cutout
Bottom
cutout
