Boldan Oy, Matkuntie 3, FIN-05200 Rajamäki | www.boldan.
fi
| +358 (0)9 853 1042
Miniroller D200 e
Manual
5
• EMERGENCY/STOP -indicator lights up, when Miniroller is ready to use. EMERGENCY/STOP does not
work, if RUN-switch has been turned on. RUN-switch must always be turned to position 0 to con
fi
rm.
• MODE-switch has two positions: foot pedal (PEDAL) or manual steering (SWITCH).
• RUN-switch directs roller backwards (REV) or forward (FW).
• RUN SPEED -switch adjusts the speed of rollmotors.
• Control panel can be attached onto calibration roller or released. If released the control panel can be
hooked up within 1,5 meter (5 ft) distance with a cord that comes along.
• Control panel can be released by turning the black knobs fully open (seen in picture).
• Rollers can be controlled by foot pedal also. Foot pedal can be hooked up into the control panel by the
socket on the side of the control panel case.
• When drive mode has been set up for foot pedal, the rollers will roll only when pressing the foot pedal.
• Liner has to be placed between the rollers before turning rollmotors on.
• Recommended temperature for use of calibration roller is 10 - 30°C (50 - 86°F).
