+
_
+
_
70V
25V COM GND
70V
25V COM GND
TEL
MIC
BAL
GND
+
MUSIC
MUTE
MUSIC IN
BRIDGING
T
R
MODEL TPU250
250 WATT AMPLIFIER
ALC
TEL VOLUME
MIC VOLUME
BOGEN COMMUNICATIONS
GND
MUSIC
IN
CONTACT
RING
TEL
RING
APHEX
Output Wiring
All output wiring connections are made to the terminal strip located under the right
side access panel. Loosen the 2 Phillips-head screws on each side of the cover and
remove the cover.
IMPORTANT: Before making any connections or wiring changes to the amplifier
or any equipment connected to the amplifier, make sure that the amplifier is NOT
plugged into an AC outlet.
NOTE: The amplifier does not have a power switch, so it must be unplugged in
order to turn the power off.
Speaker Connection
70-volt speaker connections are made between the 70V and COM terminals on the
output terminal strip (see Figure 7). Use a 22 AWG shielded, twisted pair cable.
Connect the shield of the cable to the GND terminal of the output terminal strip.
The COM and GND terminals of the output terminal strip are connected using a
shorting clip. The shorting clip enables the amplifier output to act as an unbalanced
output (one side of the output connected to ground). If desired, the output can be
made to be a balanced output with no connection to ground.To balance the output,
simply remove the shorting clip. All speaker connections remain the same as above
including connecting the shield to the GND terminal.
NOTE: The amplifier output terminal strip includes a terminal for 25V speaker
connections. This is provided for special applications and is generally not used.
Page 9 of
1
2
Figure 7: Speaker Connection, Output Wiring
Output Terminal Strip