Installation
The TPU amplifiers are designed for wall-mount applications, but can also be
mounted in a standard 19" rack using the included rack adapter brackets.
To mount the amplifier in a 19" rack, it is first necessary to attach the rack adapter
brackets to the amplifier flanges
(see Figure above)
. Start the four 1/2" truss-head
self-tapping screws into the two small round holes in each of the adapter brackets.
Be certain to secure the screws from the correct side of the brackets. The brackets
should mirror each other so that they can be installed on opposite sides of the
amplifier. From behind the amplifier, slip the rack adapter, with screws, through
the opening in the keyhole slots and slide them up in to the keyhole slots. Tighten
the screws securely. Lift the amplifier up to the front of the rack and secure it to
the rack with the necessary screws
(not included)
. The amplifier will protrude out
from the front of the rack.
SCREW 1/2"
TRUSS-HEAD
RACK
MOUNTING
SCREWS ARE
NOT SUPPLIED
Model: RPK82
TPU35B/60B/100B
Rack Mounting Kit
Rack Mounting the Amplifier
NOTE:
The amplifier will produce heat during operation which will rise and may
cause problems for temperature-sensitive equipment mounted above it.
Mount the amplifier near the top of the rack so that no other equipment
will be above it. If this is not possible, then allow at least 12" of
open space above the amplifier and 4" below for adequate air circulation.
Specifications subject to change without notice.
© 2000 Bogen Communications, Inc.
Part No. 54-2031-01E 0912
50 Spring Street, Ramsey, NJ 07446
Tel. 201-934-8500 • Fax: 201-934-9832
www.bogen.com
Installation
The TPU amplifiers are designed for wall-mount applications, but can also be
mounted in a standard 19" rack using the included rack adapter brackets.
To mount the amplifier in a 19" rack, it is first necessary to attach the rack adapter
brackets to the amplifier flanges
(see Figure above)
. Start the four 1/2" truss-head
self-tapping screws into the two small round holes in each of the adapter brackets.
Be certain to secure the screws from the correct side of the brackets. The brackets
should mirror each other so that they can be installed on opposite sides of the
amplifier. From behind the amplifier, slip the rack adapter, with screws, through
the opening in the keyhole slots and slide them up in to the keyhole slots. Tighten
the screws securely. Lift the amplifier up to the front of the rack and secure it to
the rack with the necessary screws
(not included)
. The amplifier will protrude out
from the front of the rack.
SCREW 1/2"
TRUSS-HEAD
RACK
MOUNTING
SCREWS ARE
NOT SUPPLIED
Model: RPK82
TPU35B/60B/100B
Rack Mounting Kit
Rack Mounting the Amplifier
NOTE:
The amplifier will produce heat during operation which will rise and may
cause problems for temperature-sensitive equipment mounted above it.
Mount the amplifier near the top of the rack so that no other equipment
will be above it. If this is not possible, then allow at least 12" of
open space above the amplifier and 4" below for adequate air circulation.
Specifications subject to change without notice.
© 2000 Bogen Communications, Inc.
Part No. 54-2031-01E 0912
50 Spring Street, Ramsey, NJ 07446
Tel. 201-934-8500 • Fax: 201-934-9832
www.bogen.com
