Bogen NYQUIST NQ-GA20P2, Руководство по настройке

Страница: 24 / 36

16
Selecting the Menu button displays other parameters. DSP parame-
ters and the Mute and Level buttons are described in the following
table:
6.1 Setting the Channel Level
The Channel Level control is a vertical slider that is adjusted in 1 dB
increments and that controls the input or output levels to and from
the amplifier. The Channel Levels can range from -60 dB to +12 dB. If
you place the mouse over the slider, the numerical value of the level
appears.
To adjust the channel volume level:
Step 1 On the appliance Web UI’s main page, select DSP .
Step 2 Use the slider for the Channel Level to adjust the level
for the selected channel.
Table 6, DSP Page
Mute Silences the audio.
Level Adjusts the channel volume leve in 1 dB
increments.
Compressor Lessens the dynamic range between the
loudest and quietest parts of an audio signal.
High/Low Pass Sets the band of frequencies that will pass
through the high pass and low pass filters
and selects the type of filter that is used.
Limiter Prevents a signal from exceeding an adjust-
able maximum level.
Outputs Allows you to enable speaker or line outputs
and to adjust the volume level for each out-
put.
Parametric EQ Uses a center/primary frequency to allow tai-
loring of the frequency content of an audio
signal.
Settings Allows you to provide names and colors for
the input channel.
Signal Present Illuminates green when audio is present in
the channel input.