CEILING TILE
CEILING GRID
SUPPORT RAIL CROSSBAR
Electrical Connection
Ceiling Installation
Model CSD1X2VR
Drop-In Ceiling Speaker
With Back Can and Recessed
Volume Control
70V & 25V Speaker Systems
NOTE: All wiring must comply with NFPA 70
Listed to UL Standard - ANSI / UL 1480
2-YEAR WARRANTY
The CSD1X2VR is warranted to be free from defects in material or
workmanship for two (2) years from the date of sale to the original
purchaser. This warranty does not extend to any of our products
that have been subjected to abuse, misuse, improper storage,
neglect, accident, improper installation or have been modified or
repaired or altered in any manner whatsoever, or where the serial
number or date code has been removed or defaced.
50 Spring Street, Ramsey, NJ 07446 USA
Tel. 201-934-8500 • Fax: 201-934-9832
www.bogen.com
Specifications subject to change without notice
© 2004 Bogen Communications, Inc. 54-2161-01E 1211
54-2161-01E
Lead
Color
70V
Red
25V
Yellow
COM
Black
1. Remove electrical box cover, then install
cable clamp (if desired) and feed interconnecting
cable into the electrical box.
2. Select speaker leads for desired system type:
70V - Red, 25V - Yellow, and COM - Black
for both. Interconnect the speakers in the
system, making sure that all leads of the same
color are connected together. Avoid swapping colors.
3. Cut bare wire tip off of unused speaker lead. Secure
all mechanical connections and re-install
electrical box cover.
4. Set tap selector switch to proper tap setting.
5. Speaker volume can be attenuated via front panel
recessed volume control.
1. For 2 ft. x 4 ft. tile space, cut ceiling tile to 35-1/ 2 " long.
For 2 ft. x 2 ft. tile space, cut to 11-1/2" long.
2. Place speaker in ceiling opening.
3. Slide Tile Support Rail under speaker edge beside opening.
4. Drop in the tile.
E
11-20-12
NOTES
1. MATERIAL TO BE WHITE POLYESTER FILM WITH PERMANENT ADHESIVE BACKING.
2. PRINTING TO BE PMS BLACK.
3. LABEL MATERIAL, INKS, AND ADHESIVE MUST BE UL APPROVED.
4. LABEL TO BE 5” INCHES WIDE X 7.25” INCHES HIGH.
5. SEE INSETS ABOVE FOR VENDOR TO ADD ETL CONTROL NUMBER AND COUNTRY
OF ORIGIN INFORMATION.
6. SAMPLE PROOF TO BE SUBMITTED AND APPROVED BEFORE FINAL PRINT RUN.
CSD1X2VR
CSD1X2VR
54-2161-01
MADE IN XXXXX
REPLACE
XXXXX
WITH MANUFACTURER’S
COUNTRY OF ORIGIN. FONT: ARIAL; SIZE 7 PT.
MADE IN XXXXX
INSET 2:
XXXXXXX
CONFORMS TO
UL STD 60065
CERTIFIED TO
CAN/CSA STD C22.2
NO. 60065
XXXXXXX
XXXXXXX
XXXXXXX
